Cateye TL-AU100 Manual de usuario descargar pdf

THIS IS

MADE OF

RECYCLED

PAPER .

WARNINGS:

., LTD.

REPLACING BATTERIES:

(*1)

(*2)

PAD

ø18.0~40.0mm

ASSEMBLING THE TL-AU100BS:

HP-5

ø19.0~22.8

SP-5

ø23.5~27.2

SP-6

ø26.5~30.5

SP-7

ø28.8~32.5

SP-8

ø31.0~34.5

SPARE ACCESSORIES

Before using the product, please thoroughly

read this manual and keep it for future

reference. Run times are based on use with 1.5

volt alkaline batteries. Use of rechargeable

batteries may result in a decrease of run time

and brightness.

When using this light

always make sure to slide

the light onto the bracket

completely (until it "clicks"

into place) .

2-8-25,Kuwazu,Higashi Sumiyoshi-ku,

OSAKA,Japan 546-0041

www.cateye.com.

• Although this light is being supplied with the endless clamp only, the reflector on this light only

complies with BS6102/2 when used with the fitting clamps SP-5, SP-6 or SP-7 available separately.

• Before every ride, check to see the TL-AU100BS is securely attached to the bicycle.

• Incorrect installation of the batteries can damage the TL-AU100BS.

• Do not use combinations of fresh and old batteries or different types of batteries. Always

remove expired batteries.

• If the TL-AU100BS does not turn on, the batteries may be at the end of their useful life. Replace

them with new ones.

• The battery life will vary depending on the conditions of use.

• Always Keep the reflector clean.

For UK Consumers

When used in constant flashing mode this light complies with the Road Vehicles Lighting Regulations

2005 No.2559. When used in constant mode, this light complies with British Standard 6102/3.

1. Install the rubber pad on the clamp as shown and

attach it to the seat post.

2. Assemble the bracket to the clamp with the screw but

do not tighten completely.

3. Insert the light body into the bracket until it clicks into

position.

4. Adjust the angle of the light so that:

• The reflector will face directly backwards (*1).

• The reflector will be perpendicular to the ground (*2).

5. Tighten the screw securely.

Attach the band temporarily

to the seat post.

1. Use a coin to remove the reflector.

* Using a large diameter coin

2. Insert two new AA size batteries (alkaline recommended)

and make sure of the correct polarity.

3. Install the reflector back to it's original position.

#544-0980

BRACKET

#544-0892

UNIVERSAL BAND: ø18.0~40.0

Indice de contenidos

Pagina 1 - ASSEMBLING THE TL-AU100BS:

THIS ISMADE OFRECYCLEDPAPER .WARNINGS:CO., LTD.REPLACING BATTERIES:(*1)(*2)PADø18.0~40.0mmASSEMBLING THE TL-AU100BS:HP-5ø19.0~22.8SP-5ø23.5~27.2SP-6ø2

Comentarios a estos manuales

Sin comentarios

Cateye TL-AU100 Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Cateye TL-AU100. CatEye TL-AU100 User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales